The SQL editor is where you enter your SQL commands. You can load a SQL script by clicking on the (Load script...) button on the toolbar. To save a script, click on the (Save script... ) toolbar button.


When you want to run a SQL command, select the block of text or use active text selection, then click on the (Execute script) toolbar button, or F5. If no errors were raised, the work area will open the Results tab. Any errors raised will be displayed in the errors area.


In addition to features offered by a text editor, the editor offers the following:

·

active text selection

You can run SQL queries in 2 ways. The regular way is to select the block of SQL text to run, then click on the (Execute script) toolbar button, or F5. The alternative is to place your caret anywhere in the SQL text, and click on the (Execute script) toolbar button, or F5. When you do not explicitly select a block of text, SQL Image Viewer will look for a block of text at the carets' position, surrounded by blank lines. See Editor command selection for details.

·

numbered bookmarks

The editor allows you to create up to 10 bookmarks. To create a bookmark, press CTRL-SHIFT-[0 - 9]. To go to a bookmark, press CTRL-[0 - 9]. E.g. to place bookmark 1 at the current line, press CTRL-SHIFT-1.

A bookmark indicator is displayed on that line. To jump to that bookmark from anywhere in the editor, press CTRL-1.

·

drag and drop editing

You can select a block of text by highlighting it, then by clicking anywhere in the selected block, you can then drag and drop the selected block to anywhere else in the editor.

·

bracket highlighting

When the caret is at the beginning or end of a block delimited by brackets, the corresponding bracket is highlighted.